Do not rush around searching for different products that may ruin your carpet.  Simply follow these simple steps to get the marker out.

1.)    Go to the bathroom and find the hairspray. It does not matter if it is in an aerosol can or if it is in a pump bottle. Either one will work.
2.)    Next, spray the hairspray on the floor. You do not need to spray it to the point that the carpet is soaked but you do want the area to be damp.
3.)    Use a clean cloth and begin rubbing the area until you start to see some of the marker coming out of it.  You may need to re-spray the area from time to time.
4.)    Continue repeating this process until you see the marks completely disappear.

Always remember to test an area of the carpet that will not be seen. This is the best thing to do in order to ensure that your carpet will not be ruined by the hairspray or your scrubbing.  It is always better to be safe than sorry. Check out your tips on how to effectively clean your carpet after water damage for more carpet cleaning tips.

Kitty litter. That’s right: Cleaning oil from the driveway with kitty litter is the most oft-recommended method for this type of stain removal. There is one additional material that is required when this method is implemented: dry cement. Don’t worry, you won’t be mixing it with water!

Fair warning: For best results, you should follow these steps, which will take approximately two days to complete. Again, there’s no need to worry; the job is actually very simple! To clean oil stains from concrete in five easy steps:

1. Spread a thick layer of kitty litter over the grease, and allow up to 24 hours for absorption.

2. Gently sweep the kitty litter away.

3. Cover the entire spot with dry cement.

4. Allow another 24 hours for the cement’s absorption effect.

5. Gently sweep away the dirty cement.

Gather dirty cement in a bag and throw it away (in a trash receptacle only – do not flush down the toilet or sink!).

The result? A clean driveway! Before long, you’ll be cleaning an oil stain from concrete like a pro.

To prevent stains form vinyl or other resilient tile, wipe up any spills as soon as they accrue. Stubborn stains or stains that you where unable to clean off right away may need some extra attention.

The first thing you should do is  remove the stain from the vinyl floor by wiping with a clean cloth moistened with liquid-detergent floor cleaner. If this dose not work you may use a nylon pad for more heavy residue.

If the stain  from the vinyl floor still dose not come up, try each of the following products, one at a time.

1. Rubbing alcohol
2. liquid chlorine bleach
3. turpentine
4. lighter fluid

CAUTION: Do not apply turpentine, nail polish remover, or lighter fluid to asphalt or rubber tile. Do not  apply bleach to cork flooring.

Apply each of the above products to a clean white cloth. Turn the cloth frequently while rubbing the stain from the vinyl. Allow the product to remain on the vinyl floor for 30 minutes. When the stain from the vinyl is finally gone, rinse the area with water and let dry. Apply a floor finish like polish or wax if you normally have used one on your vinyl floor.

Avoid using any abrasive scouring powders or pads. Before using any cleaning products, test it on an inconspicuous area.