A few simple steps can get you on the right track to relaxation. 

1. You want to make sure to remove the old head first.  You can do this with a pair of pliers or a wrench that is adjustable (make sure you always use the right wrench for the job).  Turn counterclockwise while grasping the shower head firmly with your free hand.

2. You may find some buildup in your old shower head you will want to clean this from the pipe before installing the new one.

3. With the use of some plumbers tape you should wrap the pipe in a thin layer in a clockwise fashion.  Please make sure to dry the surface well before doing this or the tape will not stick.

4. Now it is time for the new shower head.  You should screw it on over the tape.

5. When you feel resistance this is a good point to stop.  Make sure you do not make it too tight.

6. Now turn on the water in the shower and make sure that there are no leaks around the new head.  If there are leaks, try tightening the shower head some more to see if that stops the leak.

 Now you are on your way to a relaxing shower without all the clogs and leaking!  You may have thought the project was difficult before but with a few simple steps you can now consider yourself the perfect do-it-yourselfer!

If your shower head leaks where it meets the arm, you probably need to replace the washer. To replace the washer, loosen the collar using tape-wrapper rib joint pliers to avoid damaging the finish; then unscrew the head from the ring and remove the old washer with the new.

Weak water pressure from the shower head usually means there is a mineral buildup in the shower head. To remove buildup and restore water flow, clean outlet holes with a pin or unscrew a perforated face plate of the shower head and soak it overnight in vinegar. Once soaked over night scrub the face plate clean and rinse off.

If the shower head will not pivot with ease, check the washer for wear and tear. If the washer is fine than coat the swivel ball with petroleum jelly before reassembling the shower head.

Tip:

If the nuts and couplings are frozen in place, instead of using a wrench to force them loss, place penetrating oil on the connections. Wait half an hour, then loosen the nuts and couplings with a wrench.

Make sure you always have handy the tools to help with plumbing repairs. Most are need for the repairs that are mentioned above for fixing a faulty shower head.